Oxford Pattern making

Last Measurements

Top line of the Quarter

- Draw  a  line from point J to  point H; this line must partially overlap the middle line;

- Draw a line from  point  G; this line must partially overlap the top line of the basic pattern and be connected to thee line JH  with a  semi-chrome.

Line of the  counter

- Join point k, lying on the top line  of the quarter, at 15 mm from  point H, and point  L , lying on the lasting line at a 95 mm distance from point C.

Last Measurements

Top line of the Quarter

- Draw  a  line from point J to  point H; this line must partially overlap the middle line;

- Draw a line from  point  G; this line must partially overlap the top line of the basic pattern and be connected to thee line JH  with a  semi-chrome.

Line of the  counter

- Join point k, lying on the top line  of the quarter, at 15 mm from  point H, and point  L , lying on the lasting line at a 95 mm distance from point C.

Lower line of the  Quarter

- Mark point  M, lying at 5 mm  distance from point  G,  on the  line Gj;

- draw a curved line from point M to point  N lying on the lasting line at  a 12 mm distance  from point  L.

Intermediate line the quarter

- mark point O, on  the line JI; this point  lies  at 30 mm from point  J;

- draw a line  from point O to point  P; this line shall be partially parallel to the line JG.

Line of the Toe - Cap

 - Mark point  O, lying at a 25 mm  distance from point  G,  on the  line GB;

- Mark point  R, lying at a 27 mm  distance from point E,  on the  lasting  line.

- draw a curved line from point Q to point R.

Line of the Tongue

- draw a curved line from point S, lying at a  8 mm distance from  point J to point T, lying at  a 12  mm  distance from point M ; make this line intersect the instep  line on a point lying  at 27 mm from point J.

Covering  Tongue

- draw a curved line from a point lying on the  line at a  4 mm distance from  point M; this line , 10 mm long, will end  on  thee line MN.

Marking  of the Holes

- mark the first  hole at 10 mm from the  top line  f the  quarter;

- mark the second  hole at 12 mm from the  top line  f the  quarter;

- mark the third  hole at 14 mm from the  top line  f the  quarter;

- mark the fourth  hole at 16 mm from the  top line  f the  quarter;

Lines of the wedge 

- draw two lines 3 mm apart, on  the sides of the  line MN; point M lies in the middle between them and the two lines will meet  at a 40 mm distance from point M; 

- line UN: the line of the central part 

-  line VN: line of  the quarter

Inside line of  the toe-cap

- take  the  le f the toe-cap; draw  a  curved line starting from a point  lying at 3 mm from point  Q along thee toe-cap line; the maximum distance between the  toe-cap line and this curved line  is 30 mm n thee middle part of thee line. The two lines  merge  at approximately 4 mm from  point R.

Line of the upper

- mark a point on  the  lasting line, at 25 mm from point on the  toe girth

- draw aa curved  line from  point V  to point W;  this line must cross the point mentioned above.